| 中文版 English

具体要求

其它要求

-
关闭
Spätrömischer, zweischaliger Kammhelm aus Eisen, 4. Jhdt. n. Chr., dazu ein zeitgleicher Schildbucke
德国
2023年05月06日 开拍 / 2023年05月04日 截止委托
拍品描述 翻译
Sp?tr?mischer, zweischaliger Kammhelm aus Eisen, 4. Jhdt. n. Chr., dazu ein zeitgleicher Schildbuckel Sp?tr?mischer Helm vom Typ Deurne/Berkasovo mit der typischen breiten Wangenklappe (mitunter get?tigte Zuweisung an Kavallerie nicht gesichert). Kalotte aus zwei Schalen, unten mit zwei horizontal umlaufenden, von innen herausgeschmiedeten, schmalen Wülsten versehen. Vorne zwei Ausschnitte über den Augen. In der Mitte durch einen hohl ausgeschmiedeten Kamm verbunden, durch dessen seitliche R?nder auf jeder Seite acht Nieten durch Kamm und Rand der Kalottenh?lften geschlagen sind. über den Ausschnitten für die Augen ein Nasal mit Mittelknick und seitlichen, massiven B?gen mit Mittelgrat. Durch diese B?gen je zwei Nieten geschlagen, welche die Kalottenh?lften an der Stirn zus?tzlich verbinden. Die Wangenklappen au?en durch ein Scharnier mit dreiteiligem Gewerbe und halbrunden Beschl?gen beiderseits mit je drei Nieten verbunden. Die Unterseite der Wangenklappen am Rand seitlich nach Knick leicht ausgestellt und S-f?rmig geschwungen, nach unten tiefer ausgezogen, vorne mit zwei bogenf?rmigen Ausschnitten. Im vorderen Zwickel ein Loch für die Verschnürung. Der nach einem Knick nach hinten au?en abstehende Nackenschutz gleichfalls durch ein ?hnliches Scharnier mit der Kalotte verbunden, oben allerdings mit einem trapezoiden Beschlag. Die rechte Wangenklappe im mittleren und unteren Teil erg?nzt, ebenso die Spitze des Nasals. Ansonsten konservatorisch behandelte, sehr gute Originalsubstanz. L?nge von Nasal bis Nackenschutz 30 cm. H?he von Unterkante der Wangenklappen bis Kamm 30 cm. Breite 18 cm. Selten erh?ltliches Exemplar aus der Gruppe sp?tr?mischer Kammhelme, die die Tradition früh- und mittelkaiserzeitlicher Helme, deren Kalotten aus einem Stück getrieben waren, brachen. Typisch für sp?tr?mische Helme waren diese nun vielteilig konstruiert. Dazu ein wohl ursprünglich zum gleichen Komplex geh?riger Schildbuckel in auffallend ?hnlichem Erhaltungszustand. Oberer, ann?hernd halbkugeliger Teil achtfach facettiert, darunter nach innen eingezogen. Der fast rechtwinklig abstehende, kreisf?rmige Rand von 2,5 cm Breite mit drei Paaren von quadratischen Nietl?chern durchsto?en. Durchmesser 15,5 cm. H?he 9 cm. Provenienz: Aus dem Nachlass eines süddeutschen Militaria-Sammlers, erworben 2010 bei Hermann Historica in Auktion 59, Los 67. Zuvor Privatsammlung USA, erworben in den 1980er Jahren. Publiziert und ausgestellt in "Attila und die Hunnen", Historisches Museum der Pfalz, Speyer 2007, Katalog S. 250 f. Zuletzt ausführlich abgebildet und besprochen in Miks, Christian, "Ein sp?tr?mischer Depotfund aus Koblenz am Rhein. Studien zu den Kammhelmen der sp?ten Kaiserzeit", 2014, S. 231 und Taf. 119 - 121. Dort weitere Literatur mit Erw?hnung des Helms aufgeführt. A Late Roman helmet of iron with bipartite bowl and ridge, 4th century A.D., with a shield boss of the same period A Late Roman helmet of iron with bipartite bowl and ridge, 4th century A.D., with a shield boss of the same period Late Roman helmet of the Deurne/Berkasovo type with the typical wide cheek flap (sometimes attributed to cavalry, not certain). The calotte consists of two shells, the lower part has two horizontal, narrow ribs forged out from the inside. In front two cutouts above the eyes. Connected in the centre by a hollow forged ridge with eight rivets driven through the ridge and edge of the calotte halves on each side. Above the cutouts for the eyes, a nasal with a central bend and lateral, solid arches with a central ridge. Two rivets are driven through each of these arches, which additionally connect the bowl halves at the forehead. The cheek flaps are connected on the outside by a hinge with a three-part joint and semicircular fittings on both sides with three rivets each. The underside of the cheek flaps slightly flared at the edge and curved in an S-shape, extended deeper towards the bottom, with two arched cutouts at the front. A hole for lacing in the front angle. The neck guard, projecting outwards after a bend at the back, is also connected to the calotte by a similar hinge, but with a trapezoidal fitting at the top. The right cheek flap replaced in the middle and lower part, as well as the tip of the nasal. Otherwise conservatively treated, very good original condition. Length from nasal to neck guard 30 cm. Height from the lower edge of the cheek flaps to the crest 30 cm. Width 18 cm. Rarely available example from the group of Late Roman crest helmets that broke with the tradition of Early and Middle Imperial helmets whose bowls were hammered from a single piece. Typical of late Roman helmets, this one was now constructed in many pieces. In addition, a shield boss that probably originally belonged to the same complex in a remarkably similar state of preservation. The upper, almost hemispherical part is eight-fold faceted, the lower part is inwardly recessed. The circular rim of 2.5 cm width protruding almost at right angles is pierced with three pairs of square rivet holes. Diameter 15.5 cm. Height 9 cm. Provenance: From the estate of a South German militaria collector, acquired in 2010 at Hermann Historica in auction 59, lot 67. Previously private collection USA, acquired in the 1980s. Published and exhibited in "Attila and the Huns", Historisches Museum der Pfalz, Speyer 2007, catalogue p. 250 f. Last illustrated and reviewed in Miks, Christian, "Ein sp?tr?mischer Depotfund aus Koblenz am Rhein. Studien zu den Kammhelmen der sp?ten Kaiserzeit", 2014, p. 231 and plates 119 - 121. Further literature with mention of the helmet listed there. Condition: II

本场其它拍品

  • 竞价阶梯
  • 快递物流
  • 拍卖规则
  • 支付方式
竞价区间 加价幅度
0
10
100
50
500
100
1,000
200
2,000
250
5,000
500
10,000
1,000
20,000
2,000
50,000
5,000
100,000
10,000
+

价格信息

拍品估价:无 起拍价格:36,000 欧元  买家佣金: 25.00% + VAT

拍卖公司

Hermann Historica GmbH
地址: Bretonischer Ring 3 85630 Grasbrunn / Munich GERMANY
电话: +49 (0) 89-5472649-0
邮编: 80335
向卖家提问

小贴士

1. 一般拍卖公司接受的付款方式有以下几种:
现金、信用卡、转账汇款、银行支票、个人支票以及PayPal支付。
使用PayPal支付时,请留意需要在账单金额的基础上额外加上 4% 的手续费。
2. 信用卡的种类有以下几种:
3. 转账汇款时请注意银行手续费
海外拍企会要求足额到账,所以请您在汇款时,选择足额到账,或在汇款金额的基础上加上汇款手续费(如25美金)。
4. 国际转账汇款时, 您需要知道海外拍卖行以下汇款信息:
* 收款人名称
* 收款人地址
* 收款人银行账号
* 收款银行国际编码(8位字母数字组合,必填项, 如: BFKKAT2K)
* 收款银行清算码(9位数字组合,选填项)
* 收款银行名称
* 收款银行地址
5. 运输相关事项
有的海外拍卖行会替您安排和协调运输, 您只需要支付相关的运费及保险费(如您需要)即可;有的海外拍卖行会推荐几家长期合作的运输公司, 这些运输公司有着良好的信誉和高质量的工作效率,您大可放心。您只需要提供您的收货地址, 竞得拍品账单。 运输公司会根据您提供的信息给您报价, 您可以在其中选择最优的报价者来承担运输任务。然后就是付款了, 信用卡是最常用的支付手段, 当然还有其他像PayPal,转账等。
6. 进口通关可能出现的关税
国际运送的包裹在进口清关过程中如需支付关税,需由包裹接受人(即买家)自行承担。 征收标准:具体征收标准和额度以海关通知和解释为准。
7. 禁拍拍品
海外拍卖会可能会出现中国法律禁止交易的物品,如枪支、管制刀具、象牙、犀角等;中国买家不得通过本平台参与上述物品的拍卖活动;任何情形下,买家均须对自己的竞拍行为独立承担责任。
服务热线:400-608-1178
查看全部小贴士